-40%

4wd Transfer Case Pump Rub Case Saver Plate - 01-07 Chevy Silverado 2500 HD 3500

$ 21.1

Availability: 20 in stock
  • Country/Region of Manufacture: United States
  • Surface Finish: Zinc Plated
  • Condition: New
  • Transmission Model: NP236, NP246, NP261, NP263
  • Make: Chevy / GMC
  • Placement on Vehicle: Front
  • Model: Tranfer Case Pump Rug Plate
  • Interchange Part Number: SSM-BRNY
  • Engine & Components Part Type: Pump Rub Plate
  • Restocking Fee: No
  • Manufacturer Part Number: BRNY
  • Year: 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010
  • Brand: Adapt-A-Case
  • Returns Accepted: Returns Accepted
  • Item must be returned within: 30 Days
  • Warranty: Yes
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Other Part Number: SSMBRNY
  • Model Year: 01 02 03 04 05 06 07 08 09 10
  • Return shipping will be paid by: Buyer

    Description

    4wd Transfer Case Pump Rub Case Saver Plate - 01-07 Chevy Silverado 2500 HD 3500
    GM Transfer Case Pump Rub Eliminator Plate
    The Adapt-A-Case BRNY is the original, economical, practical fix for the transfer case oil pump rubbing through the transfer case housing. Use as a preventive measure before wearing a hole in your case or after transfer case repair. After repairing any holes, the plate sits between pump and case housing. This simple and elegant solution is key to avoiding a repeat of this problem.
    What is "PUMP RUB" ??
    The GM transfer cases use a gear pump inside the case that is driven off the mainshaft. The pump forces oil to the planetary as well as the drive sprocket sleeve.  Because the pump is driven by the shaft, the housing of the pump must 'float' in the rear housing.  There are 5 tabs around the housing that fit into spots in the rear housing to position the pump.  Over time, the pump can start to wear on the rear housing. GM installed a spring steel clip in the housing intended to prevent wear, but the clip can break and render it useless. GM has even updated this clips design in recent years, it is better, but still fails as the design is flawed not just the clip.
    Being that the pump housing is aluminum and is a harder material then the magnesium rear housing, it can wear a hole in the rear housing and cause a very small leak.  This leak is high enough in the case that it typically will not leak when vehicle is not moving and therefor not leaving any drops on the ground.  Typically the condition is not found until there is transfer case damage from running the case out of fluid.
    Avoid costly repairs to your transfer case by preventing this condition. Preventing this problem or fixing an existing one is as easy as one, two, three....
    1 - Clean case and repair damage with two part epoxy or have it welded
    2 - Place BRNY protector plate in the pump pocket
    3 - Continue the rebuild knowing it’s fixed
    **Full Color Installation Instructions Included!!**
    ****NOTE****
    Due to the laser-cut accuracy in the manufacturing of the BRNY and the OEM pocket design, end play is normally unchanged.
    In some aftermarket replacement case-halves a small amount of case material must be removed along pocket’s inner corner where castings can vary slightly!
    If you have a large hole in your case and the pump has done extensive damage. A new replacement case half may be necessary. It is impossible to tell the extent of the damage until the unit is disassembled and inspected. If in doubt, have it looked at by a professional.
    Applications:
    GM Transfer cases NP236, NP-246, NP261, NP263
    Model 136, 146, 246, 261, 261HD, 263HD, 263XHD, 261XHD
    Check Your TC Case Tag for Your Model.  Chart Below is Only a Guide!
    Application Table:
    YEAR
    TRUCK
    WEIGHT
    MODEL NUMBER
    1998-2007
    SILVERADO / SIERRA
    1500, 1500HD, 2500, 2500HD, 3500
    NP246, NP261HD, NP263HD, NP261XHD, NP263XHD
    1998-2003
    BLAZER/JIMMY
    -
    NP236
    1999-2005
    ASTRO/SAFARI
    -
    NP136
    1999-2007
    ESCALADE
    -
    NP246, NP149
    2002-2007
    AVALANCHE
    1500, 2500
    NP246, NP261, NP263, NP263HD
    1998-2007
    SUBURBAN/YUKON
    1500, 2500
    NP246
    PART# SSM-BRNY
    Powered by SixBit's eCommerce Solution